Contents Contents ...................2 IMPORTANT NOTICE ..............3 TO ENSURE SAFETY ..............4 List of tools to be used ............6 Installation/removal ..............7 Installing the cassette sprocket .............7 Removing the cassette sprocket ............9 Sprocket pattern ..................10 • CS-R9200 ..........................10 • CS-R8100 ..........................11 Maintenance ................13 Replacing the adhesive ring ..............13...
• All manuals and technical documents are accessible online at https://si.shimano.com. • For consumers who do not have easy access to the internet, please contact a SHIMANO distributor or any of the SHIMANO offices to obtain a hardcopy of the User's Manual.
• Be sure to follow the instructions provided in the manuals when installing the product. Only use SHIMANO genuine parts. If a component or replacement part is incorrectly assembled or adjusted, it can lead to component failure and cause the rider to lose control and crash.
Page 5
• If the chain keeps skipping during use, consult the place of purchase. • Products are not guaranteed against natural wear and deterioration from normal use and aging. • For maximum performance we highly recommend SHIMANO lubricants and maintenance products. For installation to the bicycle and maintenance •...
List of tools to be used List of tools to be used The following tools are needed for installation/removal, adjustment, and maintenance purposes. Tool TL-LR10 / TL-LR15 TL-SR24 Adjustable wrench...
Installation/removal Installing the cassette sprocket Installation/removal Installing the cassette sprocket Place all of the sprockets other than the smallest sprocket on the freewheel body. Place the sprockets in descending order from the largest sprocket. Place the sprockets so that the wide convex section of the sprocket is aligned with the wide groove in the freewheel body.
Page 8
Installation/removal Installing the cassette sprocket Place the smallest sprocket. Place the sprocket so that the protrusion on the inner side of the smallest sprocket is aligned with the groove next to the wide part of the second sprocket. Second sprocket Protrusion Smallest sprocket Align the protrusion with the groove.
Installation/removal Removing the cassette sprocket Place the lock ring into the freehub body and use a SHIMANO original tool to tighten. Lock ring 30 - 50 N·m Removing the cassette sprocket Remove the lock ring with a SHIMANO original tool.
Installation/removal Sprocket pattern Sprocket pattern CS-R9200 The thickness of the two sprocket spacers differs. Be careful when installing the sprocket spacers. <11-34T> Sprocket spacer (thick) Sprocket spacer (thin) Lock ring washer Lock ring <11-30T> Sprocket spacer (thick) Sprocket spacer (thin) Lock ring washer Lock ring...
Maintenance Replacing the adhesive ring Maintenance Replacing the adhesive ring Remove the old adhesive ring. Wipe clean any dirt, water, and oil on the surface where the adhesive ring was affixed. Affixing surface NOTICE • The adhesive force weakens if there is any dirt, water, or oil on the surface where the adhesive ring was affixed.
Page 14
Maintenance Replacing the adhesive ring Affix a new adhesive ring. Firmly press down on the adhesive ring so that it adheres firmly to the mating face of the cassette.