Bar And Chain Combinations; Spare Parts And Accessories; Disposal - Stihl MS 194 T Instruction Manual

20 Bar and Chain Combinations

For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
19.5 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
19.6 Exhaust Emissions
The CO value measured in the EU type approval
2
procedure is specified at www.stihl.com/co2.
20 Bar and Chain Combinations
20.1 STIHL MSA 194 T Chainsaw
Pitch Drive link
gauge/groove
width
1.1 mm
3/8" P
1.3 mm
1/4" P 1.1 mm
The cutting length of a guide bar depends on the chainsaw and the saw chain being used. Actual cut‐
ting length may be less than the specified length
21 Spare Parts and Accesso‐
ries
21.1

Spare parts and accessories

These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
STIHL recommends the use of original STIHL
spare parts and accessories.
Despite ongoing market observation, STIHL is
unable to judge the reliability, safety and suitabil‐
ity of other manufacturers' spare parts and
accessories; accordingly, STIHL cannot warrant
for the use of those parts.
0458-568-8321-B
Length Guide bar
25 cm Rollomatic E light
Rollomatic E,
30 cm
Rollomatic E light
Rollomatic E,
35 cm
Rollomatic E light
40 cm Rollomatic E
30 cm
Rollomatic E,
35 cm
Rollomatic E light
40 cm
25 cm
30 cm Rollomatic E
35 cm
30 cm Carving E
The measured CO value was determined on a
2
representative engine in accordance with a
standardized test procedure under laboratory
conditions and does not represent either an
explicit or implied guarantee of the performance
of a specific engine.
The applicable exhaust emission requirements
are fulfilled by the intended usage and mainte‐
nance described in this instruction manual. The
type approval expires if the engine is modified in
any way.
Nose Number of
sprocket drive links
teeth
7
9
8
–
Original STIHL spare parts and original STIHL
accessories are available from STIHL dealers.

22 Disposal

22.1 Disposing of Chainsaw
Information on disposal is available from STIHL
servicing dealers.
► Dispose of the chainsaw, guide bar, saw
chain, fuel mix, gasoline, two-stroke engine oil,
accessories and packaging in accordance with
local regulations and environmental require‐
ments.
English
Saw chain
39
44
44
61 PMM3 (Type
3610)
50
50
55
44
63 PD3 (3612)
50 63 PM3 (3636)
63 PS3 (3616)
55
56
64
71 PM3 (Type
3670)
72
64
25