Handlebar Assembly - SeaDoo GTX+ Manual

SET-UP
sbl2007-001-004_a
Press upper and lower handlebar covers
together so tabs clip in position.
Secure upper and lower covers using three K40
x 16 screws included in the predelivery kit.
sbl2007-001-005_a
Push throttle lever housing back in position and
secure in place using an M6 x 16 socket head
screw (with scotch grip — from predelivery kit).
1
F02K0KA
Place an insert [1] (from predelivery kit)
into notch in handlebar.
Slide handle grip [2] back in place making
sure it bottoms at proper place.
†† Loctite is a registered trademark of Loctite Corp.
Predelivery
[4] (with scotch grip — from predelivery
kit) and an M6 stainless steel flat washer
[3] (from predelivery kit).
CAUTION: Ensure to install flat washer
otherwise screw will damage grip end.
Torque bolt to 7 N•m (62 lbf•in).
(from predelivery kit).

Handlebar Assembly

Model(s): International Only
Install cable support [1] on steering support
[2] and secure with:
– 3 M6 x 20 hexagonal bolts and
– 3 M6 flat washers from predelivery kit .
on bolt threads.
studs on console.
3 5
4
2
2007-2
Secure with an M6 x 30 hexagonal bolt
Cover bolt by inserting rubber cap [5]
1
2
Apply Loctite †† 243 (blue – threadlocker)
Torque to 5 N•m (44 lbf•in).
Remove both wing nuts from threaded
9 / 22