Watercraft Identification; Programming Keys With B.u.d.s - SeaDoo GTX+ Manual

FINAL PREPARATION
F18E0M6
Remove seat or seat extension to expose
cooling system expansion tank [1].
F18E0N6
With vehicle on a level surface, liquid should
be between MIN. and MAX. level marks [1] of
coolant reservoir when engine is cold.
NOTE: Watercraft is level when it is in water.
When on a trailer, raise trailer tongue and block
in this position when bumper rail is level.
Add coolant to have level between marks
as required.
Use a funnel to avoid spillage.
Do not overfill.
NOTE: Use recommended coolant type as
described in the Specifications table.
Properly reinstall and tighten filler cap
then reinstall seat.

Watercraft Identification

Model(s): All
To enter watercraft identification or to program
a safety lanyard, use BRP Utility and Diagnostic
Software (B.U.D.S.) in conjunction with VCK.
Always use the latest B.U.D.S. version
that is available from BOSSWeb
(www.bossweb.brp.com).
Predelivery
1
1
2 1
F16R016
Connect VCK components and start B.U.D.S.
Choose KW2000 Protocol from Choose Protocol
option in the MPI drop-down menu [1].
Read ECM using leftmost icon [2].
Click on VEHICLE tab.
Enter purchaser name in the CUSTOMER field.
Click on second icon of toolbar Write
ECM to register new informations from
MPI memory to ECM.
Programming Keys With
B.U.D.S.
Model(s): All
Refer to SERVICE BULLETIN 2007-5 in
regards to the 3 different lanyard option
available on ALL 4– Tec's.
Only 2 lanyards are shipped per watercraft. All
models to the exception of the GTI R are shipped
with Standard key and Learning key.The GTI R is
shipped with the Standard key and the R key.
sbl2007-001-01_a
Click on KEYS tab.
2007-2 15 / 22