Arm And Disarm; Full Arm Mode - Hi-Tech SMART GUARD User Manual

ARM / DISARM
Technical problem
Doorbell zone
triggering
Fire alarm

2. ARM and DISARM

2.1. FULL ARM mode

In this mode, all zones from the selected area(s) will be monitor and
alarm will generate if any of the zones is trigger. System is ready to arm
only if all zones are closed and the ARM status indicator lights in green.
Entering a valid user code and selecting desired area number from 1 to
8 will activate its FULL ARM mode.
User code
Arming will start by counting the exit time with audible signal (short
beeps) and flashing the ARM status indicator in red. In the last few
seconds, the beeps will speed up. Exit time will end with the ARM tone -
three consecutive beeps, where the last is longer and the ARM status
indicator lights steadily red.
If the user has permissions for only one area, the system will skip
asking for its number and will go directly to the exit time.
GPS SYSTEMS BULGARIA
www.smart-hitech.eu
Three consecutive beeps, where the last is
longer.
A single short beep and the dedicated indicator
starts blinking.
Short fading beeps informing the triggering of an
"entry" zone (only in disarmed area).
Repeating beeps informing the triggering of fire
zone.
FULL ARM
FULL ARM
Copyright © GPS SYSTEMS BULGARIA LTD. 2022, v.1.2
All rights reserved.
 +359 700 20 820, +359 887376336
4004 Plovdiv 75A D. Talev Str
Area number
5 / 14
Exit time