Table of Contents
Advertisement
6 www.electrolux.com
Cabinet Leveling & Refrigerator Door
Alignment (if necessary)
• All four corners of the cabinet must rest firmly
on the floor
• The front should be slightly elevated to
• ensure that doors close and seal properly.
• Doors should align with each other and be
level.
Most of these conditions can be met by raising
or lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1. Lower anti-tip legs until they are both
touching the floor. Use a pair of pliers to
adjust.
To raise: turn leg clockwise.
To lower: turn leg counterclockwise.
2. Ensure both doors are bind-free with their
seals touching the cabinet on all four sides
and that cabinet is stable.
Anti-Tip
Legs
Door
Door
To make final door height adjustments:
Anti-Tip
Legs
1. Insert Electrolux 10mm wrench into the shaft
of the lower hinge.
2. To lower door: turn adjustment screw
clockwise.
To raise door: turn adjustment screw counter
clockwise.
Flipper Mullion
Adjust Flipper Mullion for proper connection
with the mullion guide by ensuring the flipper
mullion is folded and perpendicular to the fresh
food door. If the mullion guide is not in the
correct position, it could prevent the door from
closing completely.
Bottom Doors Vertical Alignment
Bottom Doors Vertical Alignment
In some cases the bottom doors might be
(for Quattro Models)
slightly vertically misaligned. To correct this
In some cases the bottom doors might
be slightly vertically misaligned. To
dierence it may be used the C-Shaped Shim
correct this di erence it may be used
supplied with the unit.
the C-Shaped Shim supplied with the
unit.
The shim must be installed on the bottom hinge
The shim must be installed on the
bottom hinge of the lower door lifting it
of the lower door lifting it to get access of the
to get access of the pin where the shim
pin where the shim must be attached, as follows
must be attached, as follows on the
images.
on the images.
Do
Advertisement
Table of Contents
