Buttons - Native Instruments KOMPLETE KONTROL S Series Manual

▪ All buttons and pads are equipped with LEDs that inform you about the assignment state
of the control element at any time.
▪ The display shows you additional information about the assignments.
7.3.1

Buttons

The LEDs below each button can have three states: off, dimmed and bright. Their lighting be-
havior depends on the type and state of the control element.
The LED states directly indicate the button states:
Button State
Not assigned
Assigned – Off state
Assigned – On state
For buttons in Increment mode, the Off state corresponds to the zero value, while the
On state corresponds to a value greater than zero. See section
Buttons for more information on the various button modes.
Controlling the Button State
The On/Off state of each button can be controlled in two ways — internally via your actions on
the button, or remotely via MIDI feedback:
▪ In Toggle mode, both controls are enabled: both your actions on the button and the possi-
bly incoming MIDI messages are taken into account to update the button and LED state.
▪ In Trigger, Gate, and Increment mode, you can choose which control mode (internal or re-
mote via MIDI) you want to use. This is done via the
the Inspector.
For more information on the button modes,
see ↑25.6.2, Assignments for
Moreover, for the F1–F3 buttons and for the Control encoder, the particular assignment is
shown within the display in Control display mode (see section
LED State
Off
Dimmed
Bright
LED On
Buttons.
Using Your MASCHINE MIKRO Controller
↑25.6.2, Assignments for
LED On menu in the
menu, and MIDI feedback mode,
↑7.4.2, Control Display
CONTROLLER EDITOR - Manual - 89
Visual Feedback on Your Controller
Assign pane of
Mode).