Native Instruments KOMPLETE KONTROL S Series Manual page 162

▪ Assigned, in Off state.
▪ Assigned, in On state.
The following paragraphs describe how the LED under each button keeps you informed on the
button states.
Single-Color Buttons
For all buttons except the Cue/Sample Trigger buttons 1–4 (on either side of your controller),
the LEDs can have three states: off, dimmed and bright. The LED states directly indicate the
button states:
Button State
Not assigned
Assigned – Off state
Assigned – On state
For buttons in Increment mode, the Off state corresponds to the zero value, while the
On state corresponds to a value greater than zero. See section
Buttons for more information on the various button modes.
Multicolor Buttons
The eight Cue/Sample Trigger buttons (four on either side of your controller) are equipped with
RGB LEDs. This by far extends the monitoring possibilities of these control elements. Indeed,
you can choose which from the 16 available colors you want to use for the On and Off states —
and this, for each button individually!
The Cue/Sample Trigger buttons offer you three Color modes:
▪ Single mode: You can choose a color that will be used bright and dimmed for the On and
Off states, respectively. In this mode, the button's lighting behaves like that of single-color
buttons (see table above).
▪ Dual mode: You can choose a color for the On state and another color for the Off state.
Both colors will be used at full brightness.
LED State
Off
Dimmed
Bright
Using Your TRAKTOR KONTROL Z2
Visual Feedback on Your Controller
↑25.6.2, Assignments for
CONTROLLER EDITOR - Manual - 162