Native Instruments KOMPLETE KONTROL S Series Manual page 130

(2) Matrix: The 8x8 matrix holds 64 freely assignable buttons. If the
abled in the Pages pane of the Inspector, the eight Scene buttons
you to select the desired page of assignments for the matrix buttons. Otherwise these Scene
buttons are also freely assignable.
(3) Touch Strips: The eight Touch Strips are freely assignable. If the
is enabled in the Pages
Strips allow you to select the desired page of assignments for the Touch Strips. Otherwise
these Group buttons are also freely assignable.
(4) Transport section and SOLO/MUTE buttons: The eight buttons in the bottom row are freely as-
signable.
(5) I/O and Level section: Both
ble. If the I/O and Level Pages
GRP, IN 1, and Cue buttons under the
assignments for the LEVEL
also freely assignable.
(6) Bottom right column: The seven buttons under the Control encoder are freely assignable.
(7) FOOTSWITCH input: The
freely assignable and can be controlled using a footswitch. Note that this is a stereo input: You
can assign MIDI messages to the tip and ring inputs independently.
(8) SHIFT button: The SHIFT
MIDI mode and MASCHINE mode from your controller (see
You can also split the controls of your controller between MIDI mode and MASCHINE
mode in order to control a MASCHINE plug-in instance while sending MIDI messages to
the host with the transport controls. See
Assignment Parameters
The following table summarizes where to find all assignment details for each type of control
element on your controller:
pane of the Inspector, the eight Group buttons
LEVEL meters as well as the Control encoder are freely assigna-
button is enabled in the
LEVEL
meters and the Control encoder. Otherwise these four buttons are
FOOTSWITCH input, located on the rear panel of your controller, is
button cannot be assigned, instead it allows you to switch between
↑25.5.1, Templates Pane
Matrix Pages
1–8
Touch Strip Pages
Pages pane of the Inspector, the MST,
meters allow you to select the desired page of
↑10.1, Basic
for more information.
CONTROLLER EDITOR - Manual - 130
Using Your MASCHINE JAM Controller
Assignable Control Elements
button is en-
above the matrix allow
button
A–H above the Touch
Controls).