Hyundai BSB 284 WW User Manual page 10

● Before connecting the appliance to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during
transportation.
● Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your beverage center
● Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded. To level your appliance, adjust the legs at the front of the appliance.
● Allow 5 inches of space between the back and sides of the appliance ,which allows the proper
air circulation to cool the compressor.
● Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the appliance not to perform
properly.
● Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to
form quickly on the evaporator.
● Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions con-
cerning power and or grounding should be directed toward a certified electrician or an authori-
zedr products service center.
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by an authorized products service center.
Reversing the Door Swing of Your beverage center
This beverage center has the capability of either opening the door from the left or right side. The
unit is delivered to you with the door opening from the left side. Should you desire to reverse the
opening direction, please follow these instructions.
NOTE:
Before Reversing the door ,the power must be shut off.
All parts removed must be saved to do the reinstallation of the door.
This beverage center has been built with the door hinges on the left. If you wish to change the
opening direction, follow the instructions below:
1. Remove the upper hinge cover(6) first
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the
frame. Take away the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws (10) that hold the handle (11) (on the right side frame).
Change the handle to the left side frame.
5. Remove the two screws(8) that hold the lower hinge(2) and Make sure to Remove the lower
hinge(2).
6. Remove the left front leg (4) and transfer it to the right side.
7. Remove the hole cover plate(7) to the right side.
8. Before placing this lower hinge(2), remove the bolt-pin (9) and reverse the direction of the lower
hinge(2). Then install the lower hinge (2) onto the left side of the lower frame with two screws
(8).
9. Insert the bolt-pin(9) to the lower hinge (2).
10. Set the door to its place making sure the door seat at the lower hinge(2)
EN - 10 EN - 10