Pause Feature - Lanberg SR-1105 User Manual

Furthermore, the presence of the substances below in the room may have a negative effect on the
EN PL
detector's operation and, as a result, cause false alarms:
Methane, propane, iso-butane, isopropanol, ethylene, gasoline, ethyl acetate, hydrogen sulfide,
alcohol-based products, paints, thinners, solvents, adhesives, hair sprays, aftershave solutions, perfumes,
and some cleaning supplies.
Failure to comply with the above recommendations may damage the device, resulting in shorter service life.
H. Pause feature
It allows us to temporarily switch the alarm signal off, resulting from the detection of carbon monoxide. To mute
the device, press the "TEST" button at the time of the warning signal.
In pause mode, the device will mute for 10 minutes. If, after 10 minutes, the concentration still exceeds 50PPM,
the alarm will start again. If the carbon monoxide concentration exceeds 150 PPM during the pause mode, the
sensor will trigger the alarm immediately.
CAUTION: The TEST button should only be used to enable the pause function if you have the ABSOLUTE
CERTAINTY that your current CO concentration will not harm your health and safety.
CAUTION: The pause feature only serves to make the device more convenient to use, absolutely NOT to solve
carbon monoxide problems. It is recommended that you always check the house / apartment / room when carbon
monoxide is detected inside. Under no circumstances, do not remove the sensor to halt the alarm. Use the pause
feature for this purpose.
Failure to comply with these warnings can ave serious consequences, leading to health damages and even death.