Table of Contents
Advertisement
TX50 Videoconferencing Endpoint
Product Overview
5.4 SiteCall
SiteCall is a unique conference function provided by Huawei. It allows users to define
conferences and participants on the endpoint, making it simple to initiate a multi-party
conference. Users can create conferences using the touch panel, web interface, or remote
control of the endpoint. After setting conference parameters (such as the conference name,
data rate, and number of sites), the users can start the conference. The endpoint can initiate
conferences through H.323 or SIP.
5.5 P2P to Multipoint
When the endpoint is connected to an MCU, you can turn a P2P call into a multipoint call,
increasing conference efficiency. Below are different scenarios where this may be necessary.
Local Site Receiving Calls from Other Sites
If two sites are having a P2P call and one of the sites receives another incoming call (or
multiple incoming calls), that site can perform one of the following operations:
l
l
l
l
l
Local Site Placing Calls to Other Sites
If two sites are having a P2P call and one of the sites calls another site (or multiple sites), that
site can perform one of the following operations:
l
Issue 05 (2017-10-31)
NOTE
The TX50, with H.265 4K x 2K enabled, cannot initiate SiteCalls.
NOTE
If the H.265 4K x 2K video capability is enabled for the TX50, the function of switching a P2P call to a
multipoint call will be unavailable.
Answer&Merge: Answer calls from other sites and turn the P2P call into a multipoint
conference.
Answer&Hold: Answer calls from other sites and place the original P2P call on hold.
Then you can place calls on hold or merge calls as follows:
– Call Hold: The site in an active call can be placed on hold or released, and the site
on hold can be resumed off hold or released. In call hold state, the local and remote
sites cannot hear or video each other. They can do this only after the call hold
operation is canceled.
– Merge: Place the original P2P call on hold, and set up a call with another site or to
several other sites, and turn the P2P call into a multipoint conference.
Answer&Release: Answer calls from other sites and release the original P2P call.
Ignore: Ignore calls from other sites, close the incoming call notification dialog box, and
continue the original P2P call.
Reject: Reject calls from other sites and continue the original P2P call.
Hold&Call: Place the original P2P call on hold and place a call to another site or to
several other sites.
Then you can place calls on hold or merge calls as follows:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Functions and Features
16
Advertisement
Table of Contents
