Installation And Connection; General Advice; Connecting The Power Cable - TBB NEMO Series Manual

DX1230, DDX1230,IDX1230,
IDDX1230
DX1215, IDX1215, DX2415, DDX2415,
IDX2415, IDDX2415, DX2415L,
DDX2415L, IDX2415L, IDDX2415L

5. Installation and Connection

For the user's operation safety, cut off the power before installation.
Please double check the battery voltage matching the model installed.

5.1 General advice

Select a suitable place to install the battery to battery charger, ensuring adequate ventilation
to the charger's metal body, free from excessive heat and vibration. The electronics are
enclosed in a sealed housing. However, the charger is NOT designed to be installed in a
location where water might short between terminals.
 All cables installed must be fused. The fuse should be installed as close as possible to
the power source (battery).
 Connections from the battery must be fused closed to the battery.
 Use M5 screws to secure the charger in a solid surface.

5.2 Connecting the power cable

Please ensure the correct polarity when connecting. Reverse polarity will
burn the fuse or damage the charger and void warranty.
Model
NEMO series battery to battery Charger
Recommended wiring
1m 2m
6mm 2 or 10mm 2
AWG9 AWG7
2 2
4mm or 6mm
AWG11 AWG9
10
5m
or 16mm 2 or 25mm
AWG5
2
or 10mm or 16mm
AWG7
10m
2 or
AWG3
2
or
AWG5