MASSEY FERGUSON 6400 Workshop Service Manual page 80

Splitting - Front frame / Perkins engine
Dimensions of the screws and nuts
• Front frame and Perkins engine with mechanical
injection
Screws
M16 x 75 mm
M16 x 85 mm
M16 x 115 mm
• Front frame and Perkins EEM engine
Screws
M16 x 85 mm
M16 x 95 mm
M16 x 105 mm
M16 x 120 mm
Reassembly
Advice for use
Use guide studs to assist reassembly of the front
frame and engine.
50. Clean the mating faces of the engine and front
frame.
51. Screw two guide studs (1) to the front mating face
of the engine (Fig. 26).
52. With the help of an operator, assemble the front
frame onto the engine as follows:
• Front frame and Perkins engine with mechan-
ical injection (Fig. 27)
53. Fit screws (2), (4) and nuts (1), simultane-
ously taking out the guide studs.
54. Tighten opposing screws and nuts to a
torque of 240 - 320 Nm in the following order
(2) (4) (1).
• Front frame and Perkins EEM engine (Fig. 28)
Reminder
If it is necessary to chock the front frame, refer
to § D.
55. Fit screws (2), (3) and (4) and nuts (1), simul-
taneously taking out the guide studs.
56. Tighten opposing screws and nuts to a
torque of 240 - 320 Nm in the following order
(2) (3) (4) (1).
02A01.14
¤
H
Nuts
M16
Nuts
M16
Fig. 26
Fig. 27
Fig. 28
Massey Ferguson 6400 - Issue 2