Install A Hot-Swap Drive - Lenovo ThinkSystem SR250 Setup Manual

Before you install a simple-swap drive:
1. Read the following section(s) to ensure that you work safely.
• "Installation Guidelines" on page 48
2. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
Note: When the eighth SATA drive is installed, the M.2 drive is disabled.
To install a simple-swap drive, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
UCjqE4XzuvdHpVM9lXt41M8g/playlists
Figure 71. Simple-swap drive installation
Step 1. Slide the drive into the drive bay. Make sure the drive handle is in the open position.
Step 2. Lock the drive into place by rotating the drive handle inward until it clicks.
After you install all simple-swap drives, complete the following steps:
1. If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
2. Reconnect power cords and all external cables.

Install a hot-swap drive

Use this information to install a hot-swap drive.
Before you install a hot-swap drive:
1. Read the following section(s) to ensure that you work safely.
• "Installation Guidelines" on page 48
2. Remove the filler panel from the drive bay. Keep the filler panel in a safe place.
3. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
Note: When the eighth SATA drive is installed, the M.2 drive is disabled.
To install a hot-swap drive, complete the following steps:
Watch the procedure
ThinkSystem SR250 Setup Guide
78
https://www.youtube.com/channel/
.