Table of Contents
Advertisement
EMERGENCY AND BREAKDOWN ASSISTANCE
11, 12. Once a tire inflation pressure of at
least 180 kPa (1.8 bar, 26 psi) has been
reached.
•
Switch the compressor to "0".
•
Pull the power plug from the 12 volt
power socket connection.
•
Slowly unscrew the hose from the tire
valve (sealant residues may escape
from the hose) and put the protective
cap back onto the hose.
•
Leave the bottle in the holder. This
avoids unexpected leakage of sealant
residue.
•
Make sure the Puncture repair Kit, the
cap of the bottle and the orange cap
are stored safely, but are still easily ac-
cessible, in the vehicle.
The kit will be needed again when you
check the tire pressure.
13, 14. Immediately start and drive for
about 3-10 km (2-6 miles) so that the
sealant can seal the damaged area. Do
not drive for more than 10 min and not any
faster than 80 km/h (50 mph) (observe the
decal indicating the permissible speed).
160
WARNING
If heavy vibrations, unsteady steering
behavior or noises should occur while
driving, reduce your speed and drive
with caution to a place where it is safe
for you to stop the vehicle. Recheck the
tire and its pressure. If the tire pressure
is less than 130 kPa (1.3 bar, 19 psi) or
if there are any visible cracks, bumps or
similar damage on the side wall, do not
continue to use the tire!
Step 2 Checking The Tyre Pressure
15.
Stop the vehicle after driving about
3-10 km (2-6 miles). Check and, where
necessary, adjust the pressure of the dam-
aged tire. Remove the protective cap from
the end of the hose. Screw the hose firmly
onto the valve of the damaged tire.
16. Read the tire pressure from the pres-
sure gauge.
If the pressure of the sealant-filled tire is
130 kPa (1.3 bar, 19 psi) or more, it must
now be adjusted to the pressure specified
for your vehicle (Refer sticker on vehicle).
WARNING
If the tire check shows that the pressure
of the sealant-filled tire is less than 130
kPa (1.3 bar, 19 psi) or if there are any
visible cracks, bumps or similar tire
damage on the side wall, you must not
continue to use that tire.
•
Make sure that the compressor switch
is switched off to "0".
•
Insert the power plug into the 12 volt
power socket connection.
•
Start the engine (only if the vehicle is
outdoors or in a well ventilated area).
WARNING
Asphyxiation may occur if the engine is
allowed to run in a non-ventilated or
poorly ventilated area (e.g. inside a
building )
17,18. Switch the compressor on to "I"
and pump the tire up to the specified tire
pressure within max. 10 minutes.
Advertisement
Table of Contents
