GE Profile JDP47WFWW Specifications

2000_drop_in.eps
TM
JDP47BF/CF/WF – GE Profile
30" Min.
6" Min.
from walls

Dimensions (in inches)

30" Min.
23-3/16
If necessary,
build upsides
to 1-1/4" thick 27-1/2
to provide
countertop
36
support
30
24
2-7/8"
To Front Surface
of Countertop
20-5/8" Door
Clearance
From Front
Surface of
Countertop
Specification Revised 9/04
220824
2000_drop_in.eps
Shave Raised Edge To Clear
31-1/8" Wide Control Panel 30" Drop-In Electric Range
™
9/16
Acceptable Electrical Outlet
Area Also In Adjacent
15" Min.
Cabinet Or Under Floor 6" Min.
Conduit is 40" long
from walls
25
23-3/16
7-1/2
If necessary,
build upsides
to 1-1/4" thick 27-1/2
to provide
countertop
36
support
Accessory
Backguard
A/B
31-1/4
27
2-7/8"
To Front Surface
of Countertop
26-1/2
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
30" Min.
9/16
30" Min.
Acceptable Electrical Outlet
Area Also In Adjacent
15" Min.
Cabinet Or Under Floor
Conduit is 40" long
25
7-1/2
30
Accessory
Backguard

KW Rating

240V 11.6
24
31-1/4
208V
8.7

Breaker Size

240V 40 Amps
208V
40 Amps
27
20-5/8" Door
Clearance
From Front
Surface of
Listed by
Countertop
Underwriters
Laboratories
R
26-1/2

Optional Kits For Drop-In Electric Ranges

(Available At Additional Cost)
Maintop Filler Lower Trim Kits
(Fills gap between cooktop and (When a drop-in is installed in an
wall when unit is installed in existing cutout greater than 27-1/4"
30" free-standing cutout) from the counter to the cabinet
JXS66WW—White cross-rail, a lower trim kit should
JXS66CC—Bisque be used to fill the gap at the
JXS66BB—Black bottom of the range)
JXS96WW—White

Accessory Backguards

JXS96CC—Bisque
(Attaches to the back of range as
a backguard when unit is installed
in 30" free-standing cutout)
JXS37WW—White
JXS37CC—Bisque
JXD37BB—Black/Stainless
Note: Cabinets installed adjacent to drop-in electric ranges must have an
adhesion spec of at least a 194°F temperature rating.
Note: All 30" Drop-In Radiant Ranges conform to U.L. requirements for 0"
spacing from range to adjacent walls below countertop. To reduce possibility
of scorching the side walls above the countertop when no load is present on
burners, it is recommended that a minimum 6" spacing from adjacent side
A/B
wall be allowed for possible extended high-heat element operation.
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
IMPORTANT: 30" DROP-IN RANGES ARE DESIGNED TO HANG
FROM THE COUNTERTOP. IT DOES NOT REST ON THE FLOOR.
FOR INSTALLATION ALTERNATIVES, REFER TO INSTALLATION
INSTRUCTIONS PACKED WITH PRODUCT.
For answers to your Monogram, ® GE Profile
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center service, 800.626.2000.
®
™ or