Blue Clean E12B Original Instructions Manual page 20

20
English
3.1.14 W
. NEVER move the appliance by pulling on the POWER CABLE.
Arning
3.1.15 W
. The use of non-original accessories and any other accessories not
Arning
specifically intended for the model in question is prohibited. All modifications
to the appliance are prohibited. Any modifications made to the appliance shall
render the Declaration of Conformity null and void and relieve the manufacturer
of all liability under civil and criminal law.
3.2 SAFETY "MUSTS"
3.2.1 W
. All electrical conductors MUST BE PROTECTED from jets or splashes of water.
Arning
3.2.2 W . The electric supply connection must be made by a qualified electrician and comply with
Arning
IEC 60364-1.Either a residual current device that will cut off the power supply if the leakage current
to earth exceeds 30 mA for 30 ms or a ground fault interrupt device must be installed.
3.2.3 W . DURING start-up, the appliance may generate interference on the electrical system.
Arning
3.2.4 W
. Use only approved electrical extension leads with suitable conductor cross-section.
Arning
3.2.5 W . Always turn off the switch when leaving the appliance unattended.
Arning
3.2.6
W . The air flow may cause parts to rebound: wear all the protective clothing and equipment
Arning
(PPE) needed to ensure the operator's safety.
3.2.7 W . Switch the appliance off and disconnect it from the power source before any assembly,
Arning
maintenance, storage and transport operations.
3.2.8 W
. Maintenance and/or repair of electrical components MUST be carried out by qualified staff.
Arning
3.2.9 W . Before each use, and periodically, CHECK that screws are tight and all appliance
Arning
components are in good condition; inspect for broken or worn parts.
3.2.10 W . To ensure the appliance's safety, only use the manufacturer's genuine parts, or other parts
Arning
which carry its approval.
3.2.11 W
. Unsuitable extension cords can be dangerous. If an extension cable is used, it must be
Arning
suitable for outdoor use, and the connection must be kept dry and off the ground. Use of a power
cable reel which keeps the socket at least 60 mm above the ground is strongly recommended.
95381_E12B.indb 20 2019/6/3 下午4:15