Advertisement
2) Position of the connector in the mounting process
Design multi-pin connector layouts that do not require a swinging movement
during pickup and mounting.
In many cases, deviation of the connector mounting position is caused by the
inertia of the swinging movement of the mounter. A layout that does not require
swinging is thus required.
●Example of a connector layout requiring a swinging movement in the mounting process
Embossed tape
3) Prevention of problems during use
(1)The F4S connectors have a simple locking structure, but make sure to
consider preventive measures against the detachment of mated connectors
during practical use.
- Make sure to eliminate any gaps between the casing and board.
- We recommend that the holding force is set greater than the insertion force of
the connector.
- Select an appropriate cushioning material with a suitable shape and dimensions,
and hold down the
center, it may cause detachment of mated connectors.)
Panasonic Corporation
industrial.panasonic.com/ac/e/
Pickup and mounting positions
Connector
Connector
Casing
Connector
Sub-board
(flexible board)
connector at the
Operation manual for Narrow-pitch connectors F4S
△
Rotary inertia is applied
○
No rotation inertia
Cushioning material
Reinforcing plate
Motherboard
center. (If the holding position is off the
©
- 4 -
Panasonic Corporation 2017
Motherboard
ACCTF5E-5 201704
Advertisement
