Advertisement
Installing the Kit
1. Nut (16 mm)
2. Washer (16 mm)
3. Pin (8 mm)
4. Grease fitting
5. Washer (10 mm)
6. Hex nut (10 mm)
7. Pin (25 mm)
8. Split pin
Note: The instructions below refer to the conversion of
the cutting unit from a fixed configuration to a floating
configuration.
The remaining cutting units can be converted by following
the same procedure.
Refer to the relevant Operator's Manual for cutting unit
installation instructions.
1. Secure the float-casting pivot to the cutting unit by
inserting the pin (25 mm) through the tapered bushings
in the cutting-unit frame and the appropriate hole in
the casting
(Figure
2. Secure the pin (25 mm) in position with the pin (8 mm)
as shown in
Figure
3).
3.
Figure 3
9. Float-casting pivot
10. Bushing (30 x 20 mm)
11. Bushing (25 x 25 mm)
12. Carriage bolt (M10 x 8.8 mm)
13. Roller
14. Right wing-head stop
15. Left wing-head stop
16. Bolt (M16 x 120 mm)
3. Install the bolt (M16 x 120 mm), washers (16 mm), and
nut (16 mm) as shown in
4. Tighten the fasteners such that the float-casting pivot
can freely move through its full range of movement.
5. Replace the cutting unit back onto the arm by reversing
the removal process described previously.
6. Replace the 2 front cutting unit transport rollers with
the 2 rollers supplied
7. Install the 2 wing-head stops to the relevant cutting
unit using the carriage bolts, washers (10 mm), and
nuts (10 mm) as shown in
3
Figure
3.
(Figure
3).
Figure
3.
g199808
Advertisement
