Advertisement
Preparing the Machine
1. Park the machine on a level surface.
2. Lower the cutting units.
3. Engage the parking brake.
4. Shut off the engine and remove the key from the key switch.
Preparing the Cutting Units
1. Release the cutting unit from the arm by removing the
locknut (24 mm) and plain washer from the cutting
unit pivot pin. Refer to the relevant machine Operator's
Manual.
2. Remove the cutting unit from the pin.
Note: It is not necessary to disconnect the cutting
unit hydraulic hoses during this stage.
3. Remove the fasteners and bushings that hold the fixed
cutting unit casting in position on top of the cutting
unit and remove the casting.
Note: All fasteners and removed components should
be retained throughout the conversion process. Once
the kit is fully fitted, any parts left over can be discarded.
4. Before assembling the float/pivot casting to the cutting
unit, ensure that the bushings are pushed fully into their
bores, and that the grease fittings are installed securely.
Figure 2
Figure 1
g196882
2
g196985
Advertisement
