Motor Driver Replacement
Motor Driver Removal
Motor Driver Installation
Motor: Service and Repairs
1. Park the machine on a level surface and wait for all moving parts to stop.
When removing or installing the battery, do not allow the battery
terminals to touch any metal parts of the machine. Do not allow
metal tools to short between the battery terminals and metal parts
of the machine.
2. Lift the battery cover and remove the battery from the machine.
3. Pull and remove the chute control rod from the machine.
4. Remove the 2 screws securing the controller cover to the battery.
5. Remove the 4 screws securing the motor driver to the battery container skirt.
g320303
6. Lift the motor driver from the battery container skirt and disconnect all the
wire attachments. Remove the motor driver.
1. Connect all the wire attachments to the motor driver.
2. Install the 4 screws securing the motor driver to the battery container skirt.
Torque the screws to 1.1-1.7 N • m (10-15 in-lb).
WARNING
Figure 67
Page 8–4
60V MAX e21 Power Clear® Snow Thrower with
Flex—Force Power System® Service Manual
3438-775 Rev A