Safety Instructions - bon E-30 Instruction Manual

3 Safety instructions

3 Safety instructions
Please follow the legal requirements on accident prevention and observe the following safety
instructions!
Setting-up and assembly:
The refraction unit should not be assembled and operated in damp rooms.
Ensure that the device is on a level and stable surface during assembly.
The mains voltage must be the same as stated on the product label.
The max. weight-bearing capacity of the exchangeable table (3) is 30 kg/device
station.
Operation:
Do not expose the system to extremes of temperatures. It is recommended that the
product be used at temperatures of between +10° C and +40° C.
Avoid dropping or splashing water on the device.
The max. weight-bearing capacity of the examination chair (7) of 170 kg must not be
exceeded.
Ensure that the patient keeps his/her hands away from the exchangeable table.
There is a risk of pinching body parts!
The examination chair is not suitable for continuous operation. After continuous
operation of 60 seconds, wait at least 9 minutes for the device to cool down.
Ensure that during operation the phoropter arm (8) does not collide with the patient's
head.
If the working place lamp (1) is used for a long time span, the housing will get hot.
You could be burned!
Other information:
Do not pull on the power cable in order to remove the plug from the socket (this
applies to equipment types without wall terminal boxes).
Run all cables properly to prevent people from stepping on tem or tripping over them.
Ensure that no damage occurs to the cable (e.g. sharp edges, excessive heat).
Before doing any repairs, maintenance or installation work always pull out the mains
plug.
bon E-30
6/27