Table of Contents
Advertisement
7 Setup
7 Setup
If you want to start the set-up process, press the following key combination on the remote
control:
You will hear a long and two short signal tones. To terminate the setup, you simply switch off
the unit by pressing the
7.1 Exchangeable table and phoropter arm
Upon delivery, the refraction unit will be programmed with these defaults. A setup is therefore
only necessary, if you want different final positions or if the programming has been lost.
Setting the position defaults for the exchangeable table and the phoropter arm:
1. Start the setup (cf. chapter 7).
2. Move the exchangeable table or the phoropter arm by using the remote control or the
control panel into the desired final position (e.g. exchangeable table into operating
position).
3. Press the [Mem.] button on the remote control until you hear a signal tone.
4. Press the same button you have used for bringing the exchangeable table or the
phoropter arm into the desired position.
5. Memorization was successful if you hear a long signal tone.
Repeat steps 2 to 5 for the other positions.
7.2 Standby
The refraction unit may be switched off automatically after its last operation after a set time
has elapsed.
1. Start the setup (cf. chapter 7).
2. Press the
the number of signal tones will increase. The following times for switching off the
refraction unit can be set:
Signal tones
1
2
3
4
5
6
7
3. To save the value, switch off the refraction unit.
[Fix 2] → [Maddox] → [Maddox] → [Fix 1]
button.
button until you hear a signal tone. If you press the button repeatedly,
Switch-off time
15 min.
30 min.
1 h
2 h
4 h
8 h
off
bon E-30
13/27
Advertisement
Table of Contents
