Starting And Stopping The Engine - Stihl FS 240 Instruction Manual

9 Starting and Stopping the Engine

► Depending on the desired amount of fuel,
determine the correct amounts of two-stroke
engine oil and gasoline in a mixing ratio of
1:50. Examples for fuel mixes:
– 20 ml Two-stroke engine oil, 1 l gasoline
– 60 ml Two-stroke engine oil, 3 l gasoline
– 100 ml Two-stroke engine oil, 5 l gasoline
► Pour two-stroke engine oil into a clean
approved fuel canister first and then add gaso‐
line.
► Stir the fuel before topping up.
8.2 Fueling the brushcutter
► Shut off the engine.
► Place your brushcutter on a level surface so
that the fuel tank cap faces up.
► Use a damp cloth to clean the fuel tank cap
and the area around it.
► Turn the tank cap counterclockwise until it can
be removed.
► Remove the fuel tank cap.
NOTICE
■ Exposure to light, direct sunlight and extreme
temperatures may accelerate fuel separation
or aging. The brushcutter can be damaged if it
is used with a fuel mix that has become sepa‐
rated or has aged.
► Thoroughly mix the fuel.
► Do not top up with fuel stored for more than
30 days (STIHL MotoMix: 5 years).
► When topping up, ensure that no fuel is spil‐
led and that the fuel level remains at least
15 mm under the edge of the tank.
► Fit the fuel tank cap on the tank opening.
0458-860-0101-A
► Turn the tank cap clockwise and tighten it
down firmly by hand.
The fuel tank is closed.
9 Starting and Stopping the
Engine
9.1 Starting the engine
► Select the correct starting procedure.
► Place the trimmer on a level surface so that
the cutting attachment does not touch the
ground or other objects.
► Remove the transport guard.
A
1
2
► Depress the manual fuel pump (1) at least 5
times.
If the following condition is met
– The engine is at ambient temperature.
► Press the choke lever (2) in at the edge and
move it to position (A).
If any of the following conditions is met:
– The engine has been running for at least 1
minute and has only been shut down for a
short break in work.
– The engine sparked in the
switched off.
► Press the choke lever (2) in at the edge and
move it to position (B).
NOTICE
■ The brushcutter can be damaged if pressed
into the ground with your foot or knee.
► Press the brushcutter against the ground
with your left hand. Do not stand or kneel
on the shaft.
English
B
1
2
position and
3
4
15