Advertisement
Change units between Km/H and MPH
Hold the UP or DOWN buttons to select between Metric or Imperial units for speed and
distance. After setting your preferred units short press the POWER button to re enter the
Maximum Motor Speed setting or hold the POWER button to save setting values and return to
Display 1.
*When adjusting any of the above three settings you can hold the POWER button to save
changes and return to Display 1. The screen will also return to Display 1 if you do not press
anything for 1 minute.
Changing Display Back Light Level
Use the POWER button to turn on your display. Next, hold the UP and DOWN buttons within
5 seconds of turning on the display. If you don't get it the first time, turn the display off and
then turn it on again before holding the UP and DOWN buttons.
Press the POWER button THREE times until the information on the screen stops flashing.
Then HOLD the UP and DOWN buttons for 5 seconds. Press the POWER button FIVE times
until you see P5 appear on the display and the information is no longer flashing.
Next, HOLD the UP and DOWN buttons again. Press the POWER button FIVE times to
advance to C6. Then use the UP and DOWN buttons to adjust "Display Back Light". The
dimmest setting is 1 and the brightest setting is 6. When you have set the preferred
brightness level, PRESS the POWER button to save your selection, then HOLD the POWER
button to exit the settings menu.
Advertisement
