Table of Contents
Advertisement
Quick Links
INSTALLER / SERVICE TECHNICIAN:
USE THE INFORMATION IN THIS MANUAL FOR THE INSTALLATION AND
SERVICING OF THE FURNACE AND KEEP THE DOCUMENT NEAR THE UNIT
FOR FUTURE REFERENCE.
HOMEOWNER:
PLEASE KEEP THIS MANUAL NEAR THE FURNACE FOR FUTURE
REFERENCE.
Printed in Canada
Printed on 100% recycled paper
ADVANTAGE
(ECM MOTOR)
Models
OFEAxx000-VV
OFEAxx000-1HVV
Caution: Do not tamper with
the unit or its controls. Call a
qualified service technician.
Manufactured by :
Industries Dettson inc.
Sherbrooke, Québec - Canada
www.dettson.ca
www.ouellet.com
2021-11-02
:
1 800 463-7043
X40239 Rev. D
Advertisement
Table of Contents
Related Manuals for Ouellet OFEA 000-VV Series
Summary of Contents for Ouellet OFEA 000-VV Series
- Page 1 Manufactured by : FOR FUTURE REFERENCE. Industries Dettson inc. HOMEOWNER: Sherbrooke, Québec - Canada www.dettson.ca PLEASE KEEP THIS MANUAL NEAR THE FURNACE FOR FUTURE REFERENCE. www.ouellet.com 1 800 463-7043 Printed in Canada X40239 Rev. D 2021-11-02 Printed on 100% recycled paper...
-
Page 2: Table Of Contents
Electric heating mode – 2 stage........9 3.3.6- TABLE OF CONTENT Heat pump heating mode – single stage ..... 9 3.3.7- Heat pump heating mode – two stage......9 1- SAFETY ..............3 3.3.8- 1.1- DANGE R, WARNING AND CAUTION ....3 3.4- AIRFLOW VERIFI CATION....... -
Page 3: 1- Safety
Ask the technician installing your furnace to show and 1- SAFETY explain to you the following items: The main disconnect switch or circuit breaker; 1.1- DANGER, WARNING AND CAUTION The air filter and how to change it (check monthly and clean or replace if necessary); The words DANGER, WARNING and CAUTION are used to Before calling for service, be sure to have the identify the levels of seriousness of certain hazards. -
Page 4: Positioning The Furnace
Figure 1: Upflow installation 2.1- POSITIONING THE FURNACE WARNING Fire and explosion hazard. The furnace must be installed in a level position, never where it will slope toward the front. Do not store or use gasoline or any other flammable substances near the furnace. -
Page 5: Conversion From Two To One Supply Wires For Model Over 27Kw
2.5- INSTALLATION OF THE THERMOSTAT WARNING A thermostat must be installed to control the temperature of the Risk of fire. area to be heated. Follow the instructions supplied with the The conductor sizing must conform to the last edition of the thermostat. -
Page 6: Equipped With Heat Anticipator Adjustment
Figure 8: 2-stage heating & 1-stage air conditioning & heat Cover the vertical sections of the supply and return air duct pump thermostat with soundproofing material; Use baffles in short radius elbows; Use flexible hangers to suspend the ducts. A heat pump or an air conditioner can be added to this furnace, in either the supply or return air duct. -
Page 7: Ac/Hp Size
2.6.2- AC/HP size 30/90: 30 second ON delay with no airflow and 90 second OFF delay at 100% airflow profile. Used when it is desirable Select System Size Installed to allow system coils time to heat-up/cool-down in The factory setting for air conditioner or heat pump size is the conjunction with the airflow. -
Page 8: Installation Of Accessories
connection terminal (DH) for use of a standard humidistat. The 2.7- INSTALLATION OF ACCESSORIES furnace control will detect the humidistat contact opening on increasing humidity and reduce its airflow to approximately 80% WARNING of nominal cooling mode airflow. This reduction will increase the system latent capacity until the humidity falls to a level which Electrical shock hazard. -
Page 9: Operating Sequence
3.3.4- Cooling mode – dehumidification circuit breaker button to see if it may have disengaged due to a power surge. If the breaker has to be pressed again, the unit NOTE: Remove jumper « J1 » on board to activate this function. must be checked by a qualified service technician. -
Page 10: Airflow Verification
3.4.2- High limit verification 3.4- AIRFLOW VERIFICATION After operating the furnace for at least 15 minutes, restrict the Verify the airflow by taking readings of the following points, while return air supply by blocking the filters or the return air register the elements are in heating mode: and allow the furnace to shut off on High Limit. -
Page 11: 5- Furnace Information
5- FURNACE INFORMATION Model: Serial number: Furnace installation date: Service telephone # - Day: Night: Service technician name and address: START-UP RESULTS Voltage: Total current consumed by the elements: Supply air temperature: Return air temperature: Supply air duct static pressure: Return air duct static pressure: Total pressure: Calculated air flow:... -
Page 12: Table 1: Sequence Of Operation
Table 1: Sequence of operation Thermostat to Control Control Mode Control Function Board 24 VAC State Electric Heat only Continous Fan Fan ON at the selected continous fan CFM (Fan switch ON) Fan OFF Fan ON at 50% of the selected Heat CFM, 1st stage of Heat ON** W1 ▼... -
Page 13: Table 2: Technical Specifications
Table 2: Technical specifications OFEAxx000-VV OFEAxx000-1HVV RATINGS AND PERFORMANCE 1/2 HP / 240V Motor 1 HP / 240V Motor Capacity Power, total @ 240V / 208V (Kw) 10 / 7.5 15 / 11.3 18 / 13.5 20 /15 23 / 17.3 25 / 18.8 27 / 20.3 30 / 22.5... - Page 14 Table 3: Airflow tables U Advantage ECM ½ HP motor NIQUE COOLING OR HEAT PUMP HEATING MODE (WITH HP-EFF SELECTED ¹) CFM ² CFM ² CFM ² AC / HP SIZE AC/HP CFM AC/HP CFM AC/HP CFM A/C size Adjustment ADJUST ADJUST ADJUST...
-
Page 15: Table 4: Airflow Tables Unique Motor
Table 4: Airflow tables U Advantage ECM 1 HP motor NIQUE COOLING OR HEAT PUMP HEATING MODE (WITH HP-EFF SELECTED ¹) CFM ² CFM ² CFM ² AC / HP SIZE AC/HP CFM AC/HP CFM AC/HP CFM A/C size Adjustment ADJUST ADJUST ADJUST... -
Page 16: Figure 15 : Furnace Dimensions
Figure 15 : Furnace dimensions... -
Page 17: Figure 16 : Electrical Diagram Unique
Figure 16 : Electrical diagram U Advantage ECM NIQUE... -
Page 18: Figure 17: Parts List, Unique
Figure 17: Parts list, U Advantage ECM NIQUE... -
Page 19: Table 5: Parts List, Unique
27 OFE-B04280 Electrical sequencer kit OFE 10kw 28 OFE-B04275 Plastic top door 29 OFE-X50053 Label logo Ouellet 30 OFE-B04349 Bottom door assembly 31 OFE-B04357-01 Blower assem bly OFE 10 @ 20kw 1/2hp -ECM 32 OFE-B04357-02 Blower assem bly OFE 23 @ 30kw 1hp -ECM...
Need help?
Do you have a question about the OFEA 000-VV Series and is the answer not in the manual?
Questions and answers