Advertisement
D
g
5.
Screw in the back seat slats using (12)
a
hardware
. Start at the top, making sure the
top of the slat is flush to the top of the chair
frame. Then work your way down to the
remaing two slats. For reference, slats are
spaced 3" from the bottom of one to the top of
the next.
While looking at the back, install the remaining
d
(2) hardware
e
end of bit
.
c
4
(2) 1-3/4" screws (
of the rail assemblies and spreader.
. These will require the larger
C
b
) on each end
D
3.
Using the 6" torx bit (hardware
the (12) 1-3/4" screws (
spreader (
F
the ends of the spreader and rails should
be flush to the two side frame assemblies.
4.
Before flipping the chair to it's feet, install
the (4) leveling mounts (hardware
threading them into the inserts located at
the four corners on the bottom of the chair.
a
d
6.
Insert sling spacer
as shown at left. Be sure it is pushed against
the back of the seat. Install (6) hardware
to hold it in place.
Insert the seat sling (
It should drop into the frame with minor
pressure applied to the frame sides.
G
b
) into the bottom
F
D
) and sling rails (
KEEP FLUSH WITH TOP OF SEAT
C
into the seat frame
G
) into the seat frame.
PB-1606 Assembly
b b
f
), screw
). When tight,
g
) by
c
Advertisement
