Rt310Tx Thermostat Pairing With The Spe868 Smart Plug Receiver - Computime Salus Controls RT310SPE Full User Manual

7. RT310TX thermostat pairing with the SPE868 smart plug receiver

The word PAIRING in the user settings means the function of synchronizing the transmitter with the receiver again, if it has been removed.
WARNING!
IN THE SET RT310SPE THE THERMOSTAT IS FACTORY PAIRED WITH THE SPE868 RECEIVER!
In order to pair the devices correctly, you must first prepare the receiver for synchronization!
1
Connect the plug to a 230V power supply (see its manual). Press and hold the button.
After 5 seconds, the red LED will flash, which means the SPE868 plug is ready to pair
3
Thermostat started pairing process.
It can take up to 9 minutes.
Attention! Forcing the pairing
process will generate a new
communication code. All receivers
previously paired with the thermostat
will be irretrievably deleted from its
memory.
6
Thermostat will go back to the
main screen and it has been paired
successfully.
16
with the thermostat.
4
TEST / PAIRING
When the red diode on the receiver
lights up continuously, the devices
have been paired on a new frequency.
TEST / PAIRING
2
TEST / PAIRING
Press and hold TEST / PAIRING
button for 3 seconds.
5
TEST / PAIRING
Press and hold TEST / PAIRING
button for 3 seconds to end pairing
process.
3 sec
3 sec