Table of Contents
Advertisement
2
User Card Installation
2-6
Align and engage mounting tab on Rear
1
I/O Module with the module seating slot
on rear of chassis.
Figure 2-4 Rear I/O Module Installation
Cards contain semiconductor devices which are
susceptible to serious damage from Electrostatic
Discharge (ESD). ESD damage may not be immediately
apparent and can affect the long-term reliability of the
device.
Avoid handling circuit boards in high static environments
such as carpeted areas, and when wearing synthetic fiber
clothing. Always use proper ESD handling precautions
and equipment when working on circuit boards and
related equipment.
CAUTION
Make certain Rear I/O Module is installed before installing the card into the
card slot. Damage to card and/or Rear I/O Module can occur if module
installation is attempted with card already installed in slot.
Card access is facilitated by removing the Front Bezel Assembly, and then
inserting the card in the appropriate slot as follows:
On underside of front bezel assembly, remove retaining screw and place
1.
aside in safe place.
(See Figure 2-5.) While firmly holding BBG-1300-FR chassis with one
2.
hand, grasp front bezel assembly and pull front bezel assembly straight
away from chassis.
BBG-1300-FR PRODUCT MANUAL
Installing Rear I/O Modules and Cards
2
Push top of Rear I/O Module toward
mounting position on chassis and
start the captive screw.
Lightly tighten captive screw.
BBG-1300-OM (V1.0)
Advertisement
Table of Contents
