Adapting Microwave Blower For Outside Back Exhaust - GE Profile Spacemaker JVM3670 Installation Instructions Manual

B4. ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
1 Remove and save screw that holds blower motor
to microwave.
Blower Motor
2 Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
BEFORE: Fan Blade
Openings Facing Up
End A
3
Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Microwave
4
Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting
Wires Routed Through Right Side
Installation Instructions
Back of
Microwave
Blower Motor
Screw
End B
After Rotation
Back of
Microwave
After Rerouting
Wires Routed Through Left Side
5 Roll the blower unit 90° so that fan blade
openings are facing out the back of the
microwave.
Before Rolling
6 Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End B
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched.
NOTE: The blower unit exhaust
openings should match exhaust
openings on rear of microwave oven.
7
Secure the blower unit to the microwave with
the screw from Step 1.
8 Replace the blower plate in the same position
as before with the screw.
17
After Rolling
Back of
Microwave
Blower Plate
Back of
Microwave
Blower Motor
Screw
Back of
Microwave
End A