Preparation Of Top Cabinet; Adapting Microwave Blower For Outside Back Exhaust - GE JVM6172SKSS Installation Instructions Manual

To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
3 Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the
wall and that the plate is properly centered under the
cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate and
the wall.
4
Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
B3. USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws and a
hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
:
CAUTION
Wear safety goggles when drilling
holes in the cabinet bottom.
Installation Instructions
Bolt End
17
B4. ADAPTING MICROWAVE
BLOWER FOR OUTSIDE BACK
EXHAUST
1 Remove and save screws that holds blower motor
to microwave oven.
2 Open the blower door by lifting it up at the back of
the microwave. Remove and save the blower shield
on the back of the microwave by sliding it up.
Remove and save the metal vent fan cover on the
back of the microwave by sliding it up.
3 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
BEFORE: Fan Blade
Openings Facing Up
End A
4 Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Microwave Oven
Blower Retaining
Screws
Back of Microwave Oven
End B
After Rotation
Back of
Microwave Oven