Adapting Microwave Blower For Outside Back Exhaust - GE PVM2070 Installation Instructions Manual

Installation Instructions
ATTACH THE MOUNTING
L==,=,=,=,=,=,=,=,=_
PLATE TO THE WALL
i
I
ii
il
' i i '_
L
Attach the plate to the wall using toggle bolts.
At least one wood screw illtlSt be used to attach
the plate to a wall stud.
[]Remove tile toggle wings ti'om tile bolts.
[]Insert the bolts into tile mounting plate through
the holes designated to go into drywall and reatmch
the toggle wings to :H" onto each bolt.
To use toggle bolts:
Mounting
Plate
Spacing for TogglesMore
-"-I---"-i*_ ThanWall Thickness
i
ToggleWings
Bolt End
[]Place tile mounting plate against tile wall and
insert the toggle wings into the holes in the wall
to mount tile plate.
NOTE: Before tightening toggle bolts and wood
scre_, make sure tile tabs on tile mounting plate
touch tl/e bottom of tl/e cabinet when pushed flush
against the wall and that the plate is properly
centered under tile cabinet.
CAUTION: Be careflfl to axoid I)inching, fingers
between tile back of tile mounting plate and tile wall.
_ Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
| USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for tile top support screws and
a hole large enouoh for tl/e power cord to fit throu ,h
" Read tile instructions on tl/e TOP CABINET
TEMPI,ATE.
" Tape it underneath tile top cabinet.
" Drill the holes, following the instructions on the
TOP CABINET TEMPL&_TE.
CAUTION:
_,,Vearsafety goggles
when drilling holes
in tile cabinet bottom.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
[] Remoxe and that holds blower motor
sa'_e screw
to IlliC I'OWa_, e.
BlowerMotor
_._...... Backof
Microwave
_2 rM°t°r
_ Careflfll} the blower unit. The wires pull
()/it
will extend far enouoh_ to allow you to a(!iust tile
blower unit.
EndA
B
16