Yamaha AUDIOGRAM 6 Service Manual page 18

AUDIOGRAM6
2-16 USB
2-16-1 Recording
In the state of the [Table 2-16.1], record onto a personal computer via USB.
* For recording procedure, refer to "Recording using the Cubase AI 4" on page 24 or "Recording using the TWE" on page 34.
Table 2-16.1 [dBu]
INPUT
XLR 1
2-16-2 Gain
Check that output level at the STEREO OUT L, R is within a range of +14.0 ± 3.0 dBu when the recorded fi le is played back via
USB.
* Set the DAW level control to maximum.
* Set the Windows volume control to maximum.
3. Phantom power
Connect the resistance of 4.7 kΩ (1W or more, margin of error should be 1% or less) between the pin 1 and pin 2 of the "CH1
XLR terminal" and short circuit between the pin 2 and pin 3.
Check that the voltage obtained between the pin 1 and pin 2 is between +25.8 V and +29.8 V when the PHANTOM switch is
turned on (LED should light).
* Phantom power is supplied at the CH1 only.
4. Initial setting
All volumes : minimum
All Switches : OFF
18
Input level
-82.0