Section 2 Disassembly; Case, Upper - Sony ECM-Z37C Service Manual

Note : Follow the disassembly procedure in the numerical order given.

2-1. CASE, UPPER

Section view
Spread and remove.
Push and
remove.
lid battery case
Note for installing the "knob, switch" :
Position the switch knob with the AMP board switch (SW1)
as shown below.
ON
OFF
2-2. MICROPHONE UNIT, AMP BOARD
1 microphone unit
5 Unsolder the
lead wires.
3 P 1.4 x 2.5
SECTION 2
DISASSEMBLY
6 grille assy, front
claws
claws
9 case, upper
7 lid battery case
4 P 1.4 x 2.5
2 Unsolder the
lead wires.
4 AMP board
0 case, lower
8 B 1.7 x 7
2 PTPWH 2 x 4
1 cap, switch
claws
3 knob, switch
5 cap, rear
Note for installing the microphone unit:
Arrange the lead wires not to be put on the LED
on the AMP board.
microphone unit
Note: Pay attention to drop of the compression
spring and stainless hall when removing
the AMP board.
Note for installing the AMP board:
Push the AMP board switch (SW1) down to position
the board with the switch knob.
ECM-Z37C
Section view
Note for installing the "cap, switch" :
Fit the claws.
claws
knob, switch cap, switch
LED
switch (SW1)
3