Table of Contents
Advertisement
Chapter 2
Modem Wake Up Connector: JMDM1
The JMDM1 connector is for use with Modem add-on card that supports
the Modem Wake Up function. To use this function, you need to enable
Wake-Up on Ring function in the BIOS setup utility.
Note: Modem wake-up signal is active "low".
Note:
To be able to use this function, you need a power supply that
provides enough power for this feature. (Power supply with 750mA
5V Stand-by)
PIN
SIGNAL
1
NC
2
GND
3
MDM_WAKEUP
4
NC
5
5VSB
2-20
1
5
JMDM1
Advertisement
Table of Contents
