4 Insert SIM and microSD card........................ 12 5 Configuration ............................ 13 Installing the driver .......................... 13 Set up Access Point Name (APN) .................... 15 Use under TwinCAT ........................ 17 Use AT commands .......................... 18 6 Diagnostic LED ............................ 19 7 Technical data............................ 20 8 Support and Service.......................... 21 CU8210-D004-0200 Version: 1.0...
Page 4
Table of contents Version: 1.0 CU8210-D004-0200...
There is a potential hazard to the environment and equipment. Notes showing further information or tips: This notice provides important information that will be of assistance in dealing with the product or software. There is no immediate danger to product, people or environment. Version: 1.0 CU8210-D004-0200...
Beckhoff Automation GmbH & Co. In addition, the following actions are excluded from the liability of Beckhoff Automation GmbH & Co. KG: • Failure to comply with this documentation.
• Change the default passwords to reduce the risk of unauthorized access. • Protect the devices with a firewall. • Apply the IT security precautions according to IEC 62443, in order to limit access to and control of devices and networks. CU8210-D004-0200 Version: 1.0...
• a USB interface for the supply of power and data transmission, • a slot for a nano-SIM (4FF) • a slot for a microSD card Structure Fig. 1: Structure of a CU8210-D004-0200 4G USB stick. Table 1: Legend for the configuration. Component Description The diagnostic LED indicates the status of the USB stick and, for Diagnostic LED [} 19]...
Product overview System requirements Table 2: System requirements - CU8210-D004-0200. Operating system Version Windows Windows 7 (32 and 64-bit) Windows 10 (32 and 64-bit) TwinCAT/BSD TwinCAT/BSD v.12.1 CU8210-D004-0200 Version: 1.0...
3. Push the microSD card into the microSD card slot with the contacts facing down. 4. Place the cover on the USB stick and push it forwards until it engages again. ð In the next step you can establish a connection to the mobile communication network. Version: 1.0 CU8210-D004-0200...
USB stick. Following the installation, a new network interface is created in Windows. Proceed as follows: 1. Connect the USB stick. 2. The USB stick is recognized as a CD drive. 3. Run the Setup.exe file to start the installation. 4. After installation, new devices are detected. CU8210-D004-0200 Version: 1.0...
Page 14
ð The drivers have been installed successfully if a new network interface appears. In the next step you can use the tool Beckhoff LTE Stick, search for the LTE stick and set up the access point name (APN) of the network provider (see: Set up Access Point Name (APN) [} 15]).
You must ask your provider for the appropriate access point information. The tool Beckhoff LTE Stick is available for setting up the APN. You can also set up the LTE stick using AT commands via a tool such as PuTTY (see: Use AT commands [} 18]).
Page 16
PIN. Normally, however, the PIN also remains stored in the stick. The interface is now ready for use and the connection to the Internet is active. Version: 1.0 CU8210-D004-0200...
4. The LTE stick can be addressed under TwinCAT via this COM port. ð In this case the COM port can be connected via the TwinCAT Function TF6340. The function TF6350 brings the SMS functionality to the machine with the help of function blocks. CU8210-D004-0200 Version: 1.0...
To reactivate the PIN request after a reboot of the stick: AT+CLCK=“SC“,1,“<your pin>“ Assign a new PIN: AT+CPWD=”SC”,”<pin old>”,”<pin new>” Show APNs already registered on the stick: at +cgdcont? Output: +CGDCONT: 1,"IPV4V6","internet.telekom","0.0.0.0.0.0.0.0.0.0.0.0.0.0.0.0",0,0,0,0 +CGDCONT: 2,"IPV4V6","internet.beckhoff","0.0.0.0.0.0.0.0.0.0.0.0.0.0.0.0",0,0,0,0 Enter new APNs: at+cgdcont= Index(max24),"IP","your apn" Example: at+cgdcont=1,"IPV4V6","internet.telekom" Delete APN: at+cgdcont=<select Index> Version: 1.0 CU8210-D004-0200...
Green, flashing Modem exchanges data in the 2G/3G network. Blue, flashing Modem exchanges data in the 4G network All colors, flashing Software is updating, no internet Red > Green > Blue access. CU8210-D004-0200 Version: 1.0...
Technical data Technical data Table 3: Technical data, dimensions and weights. CU8210-D004-0200 Dimensions (W x H x D) 97 mm x 30 mm x 14 mm Weight approx. 30 g Type 4G USB stick Chipset Qualcomm MDM 9X07 HSPA+/HSDPA/HSUPA/ WCDMA 4G band...
Please contact your Beckhoff branch office or representative for local support and service on Beckhoff products! The addresses of Beckhoff's branch offices and representatives round the world can be found on her internet pages: https://www.beckhoff.com You will also find further documentation for Beckhoff components there.
Page 22
List of tables List of tables Table 1 Legend for the configuration......................Table 2 System requirements - CU8210-D004-0200................Table 3 Technical data, dimensions and weights..................Table 4 Technical data, approvals......................Table 5 Technical data, environmental conditions..................Version: 1.0...
Page 23
List of figures List of figures Fig. 1 Structure of a CU8210-D004-0200 4G USB stick................ CU8210-D004-0200 Version: 1.0...