Advertisement
Chapter 4 Detailed Explanations on the Functions
Hotkey: SPACE = "Auto"
This chapter gives detail explanations of the programmer software functions.
Menu and Toolbar.
Select the device and device info box.
Edit in the buffer and file info box.
Window of function items for operations on devices.
Operation info window.
Status bar.
Statistics window.
4.1 Menu and ToolBar
4.1.1 File
4.1.1.1 Load
There may be one or more data buffers in the device. If more than one data buffer are
displayed after the device is selected, the buffers should be understood according to
their names and the device data manual.
The two data types of the device are Data (HEX/ASCII) and Fuse.
For most EPROM and SCM, the data type is Data (HEX/ASCII). For PLD device, the
data type is Fuse. After device is selected, the software will identify the data buffer
type automatically. You can open the buffer edit dialog box to see all the buffer data
types.
When some file data are loaded into the data buffer, the following rules apply:
HEX/ASCII data buffer (EPROM, MCU etc.). 8 bits of the data are valid.
JEDEC buffer (PLD/PAL). The lowest bit (1 bit) of the file data is valid.
The operations are shown below. After the "Load File" in the menu is selected,
the Load File box pops up.
1296 Kifer Rd. Suite #605
Sunnyvale, CA 94086
www.xeltek.com
sales@xeltek.com
Tel: +1 408-530-8080
Fax: +1 408530-0096
®
SuperPro
6100 Programmer
21 / 64
Advertisement
