MyGenie Smart Instruction Manual page 8

Robot Operation
d. Robot Operation
1. Press the right button for 2 seconds, then the robot will be set to stand by mode. Then press the
button again, the robot starts to clean, then the blue light turns bri ghter. Press the right button for
5 seconds, then the robot will turn off. (Figure 1)
2. Press the left or right button on the robot panel briefly, and blue light will turn on, at this ti me, the
machine will be under the standby mode, waiting for the next command (Figure 2).
3. Press the left button on the panel when the robot is at standby mode, at this point, the robot will
go to the auto charging station.(low battery recharge mode: the red light is on), during the
rechargi ng process, the red/blue light is blinking, and when the blue light is on after the charging,
it means it is charged.
4. Keep the robot on the charging dock after it is finished cleaning, in order to do the next cleaning.
5. If the robot is not used on a regular basis:
a.) turn off the robot to protect the battery.
b.) recharge the robot once a month to maintain the battery.
1. Lift up the robot 10cm when the robot is cleaning. The planing path
�
2: After the robot is turned on, the robot will not operate within 1 O
Attention
Figure 1
will be delete.
seconds or press and hold the left button for 3 seconds, the robot
will automatically enter the sleep mode.
Figure 2
06