Table of Contents
Advertisement
Transportation and installation
(5-4) device installation
1.Remove the device from package carefully. For this pur-
pose remove all surrounding protectors (plastofoams) and
remove the Flexoplast and put on a fully-flat standard labora-
tory table in a way that the surrounding area of the Flexoplast
is empty for a minimum of 25cm. Make sure that the surface
of the table and its legs are not metal.
If the table surface or legs are metal and in contact with
earth, there is a risk of electrocution. Therefore put the
Flexoplast device on wooden or fiberglass desks.
2.Keep the Flexoplast away from direct sunlight.
3.The user should connect the device to a feeding source with
a proper connector.
Do not use an adapter for electrical connections.
4.The user should use an electrical protector (transformer)
before the outlet to prevent the contact of overload or indirect
current with the protective parts of the device.
It is recommended for the electrical system of the laboratory
to have earth connection.
It is recommended for the environment electronic system
to have a ground connection part.
18
Advertisement
Table of Contents
