Advanced Media Settings - Canon Oce VarioPrint 110 Manual

15.3 Advanced Media Settings

The Advanced media settings are for customers who want to use advanced print
settings to avoid certain print quality issues.
The following settings can be adjusted from the operator panel through System >
Setup > Advanced media settings.
The table below describes the Advanced media settings and each setting's
description.
Setting
Pre-printed mode
*2
Wax mode
Paper quality
*1 Wax paper is a type of paper that is made moisture-proof through the application of wax.
*2 The machine has two Wax modes ('1' and '2'). Each Wax mode safely preheats the system to
prevent the deposition of wax. Select Wax mode '1' when there are print quality issues with
wax paper or any paper type. Select Wax mode '2' if Wax mode '1' does not resolve the print
quality issues. Wax mode '2' requires a higher start-up temperature, which increases the
start-up time of the machine, and requires more time for the decomposition of the wax. After
printing in the Wax mode is complete, the system is cleaned automatically, and the machine
remains in the Standby mode so that the remaining wax can be decomposed.
*3 The more the Wax mode is used, the longer the machine needs to decompose the wax. To
get optimal performance results using the Wax mode, do not print more than 50,000 sheets of
wax paper. However, if more printing is needed, let the machine remain in the Standby mode
to decompose the wax, or perform print jobs that do not require wax paper. After using wax
paper, do not power OFF the machine or put the machine into the Sleep mode. Leave the
machine in the Standby mode to allow it to clean the wax components. After a maximum of 2
hours in the Standby mode, the machine switches to the Sleep mode automatically. If 2 hours
is not enough time to decompose all of the wax, the machine remains in the Standby mode
after the next job, until all of the wax is cleaned.
Version 7 Océ VarioPrint 110 Customer Expectations Document
Description
Select if preprinted media is being used without following
the recommended guidelines for preprinted media. This
mode reduces the print speed to 60 ipm.
*1
Select if wax paper is being used, or if there are print
quality issues, such as spotting, lines, or smearing on any
paper type. After printing in the Wax mode is complete,
select the Wax mode to disable it.
Specify the Paper quality mode to improve the print
quality if low-quality paper is being used to avoid leaving
uneven, dark areas on the prints.
*3
Page 49