Naming The Device; Selecting A Source; Adjusting The Backlight Brightness; Audio Control - Fusion Apollo MS-SRX400 Owner's Manual

Naming the Device

You should enter a unique name for this device so you can easily identify it when viewing devices on the Fusion
PartyBus network.
NOTE: You should provide unique names to all of the devices and zones on the network to avoid confusion
when grouping, controlling, and setting up stereos and zones.
For further customization, you can provide unique names for the sources on each stereo and turn off unused
sources (General Settings, page
1 Select > SETTINGS.
2 Select DEVICE NAME, and enter a unique name for the device.

Selecting a Source

1 Select .
2 Turn the dial to highlight a source.
NOTE: If the device is part of a group, continue turning the dial to access the sources on other devices in the
group (Creating a Group, page
If a source cannot be shared with the group, it will appear gray and you cannot select it.
3 Press the dial to select the source.

Adjusting the Backlight Brightness

NOTE: If you connected the dim wire on the wiring harness to the boat's illumination wire, the backlight dims
automatically when the boat lights are on. This may affect how you adjust the brightness setting.
1 Select > BRIGHTNESS.
2 Adjust the brightness level.

Adjusting the Volume

Using this stereo, you can control the volume of any zone on any stereo connected to the Fusion PartyBus
network.
1 Turn the dial to adjust the volume for the home zone on the stereo.
2 If necessary, press the dial to switch between zones.
NOTE: If this stereo is part of a group, you can adjust the volume of all stereos in the group or individual
zones on each stereo

Muting all Connected Stereos

You can quickly mute the audio from this stereo or from all stereos connected to the Fusion PartyBus network
(Fusion PartyBus Networking, page
1 From any source, press
The mute symbol appears and audio from this stereo is silenced.
NOTE: If the stereo is part of a group, the audio from all grouped stereos is silenced.
2 Press and hold the dial to select MUTE SYSTEM.
Audio from all connected stereos is silenced.
3 Press and hold the dial to select UNMUTE SYSTEM.
Audio is restored to all connected stereos.
4
11).
9).

Audio Control

(Creating a Group, page
9).
.
9).
Audio Control