Air Direction - GE Zoneline AZ58H12DAD Owner's Manual And Installation Instructions

Other features your Zoneline may have.
Ventilation Control
The ventilation control lever is located at the
upper left side of the Zoneline unit, behind the
room cabinet.
NOTE: The vent door shipping hardware must be
removed before using the vent control lever.
See the Installation Instructions in this manual.
When set at the closed position, only the air
inside the room is circulated and filtered.
When set at the open or middle position, some
outdoor air will be drawn into the room. This will
reduce the heating or cooling efficiency.
Energy Tip: Keep the vent control at the closed
position. The room air will be filtered and
circulated.
To Remove the Room Cabinet
Additional controls are located behind the
room cabinet.
To remove: Pull out at the bottom to release it
from the tabs (1). Then lift up (2).

Air Direction

To adjust the air direction, remove the room
cabinet. Remove the 7 louver screws that hold
the louver insert in place. Flip the louver insert
180° , replace the screws and the room cabinet.
4
Louver screws
Louver screws
Middle position
Open position
Closed position
To replace: Place the tabs over the top rail (1).
Push inward at the bottom until it snaps into
place (2).
Remove the room cabinet and flip the louver
insert to change the air direction.