Table of Contents
Advertisement
About the controls on the air conditioner–models with touch pads.
Features and appearance will vary.
Low
Fan
On
Cool
Mode On
Air Conditioner Controls
ON/OFF
Turns air conditioner on and off.
Display
MODE
Use to set the air conditioner to COOL or FAN .
Increase
Use to set temperature when in COOL mode.
FAN
Use to set the fan speed at LOW, MED or HIGH .
CIRCULAIRE
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFF .
ENERGY SAVER–
ON– The fan and compressor cycle on and off.
This results in wider variations of room
temperature and humidity. Normally used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressor cycles off.
OFF– The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at OFF in order to use
the fan settings (on the mode control).
Remote Control
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
The remote control signal has a range of up
4
to 21 feet.
Med
High
CIRCULAIRE
ENERGY
Fan
Fan
On
SAVER On
On
On
Fan
Timer
Only
On
On
/Decrease
Pads
Controls the fan.
Remote Control
TIMER
ON– When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours
at its previous setting. Each touch will set the
time in hours.
OFF– When the air conditioner is on, it can be
set to automatically turn off in 1 to 24 hours.
Each touch will set the time in hours.
To cancel the timer, press the TIMER pad
until the display time disappears.
SLEEP
Press to set the air conditioner to run for
8 hours before it automatically shuts off.
When the SLEEP pad is pressed, SLEEP
scrolls across the display for approximately
15 seconds, then shows the time remaining.
One hour after the sleep timer is set, the set
temperature will automatically increase 1°F.
To cancel the sleep mode, press the SLEEP
pad a second time.
Note: The sleep timer will be cancelled if the
TIMER, ENERGY SAVER or MODE pad is pressed.
Remote Control Signal Receiver
Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
Make sure batteries are fresh and installed
correctly–see the Care and Cleaning section.
Advertisement
Table of Contents
