GE ASM18DK Owner's Manual & Installation Instructions page 5

When the air conditioner is turned on, it will
automatically start in the setting last used.
COOL Mode
Use the COOL mode with HIGH, MED or LOW fan for
cooling. Use the INCREASE
set the desired temperature between 64°F and 86°F
in 1°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to COOL, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
FAN Mode
Use the FAN at HIGH, MED, or LOW to provide air
circulation and filtering without cooling. Since fan
only settings do not provide cooling, a temperature
setting will not be displayed.
Vent Control
The vent control is located on the inside of the air
louvers in the lower right corner.
When set at CLOSE , only the air inside the room will
be circulated and conditioned. When set at OPEN ,
some inside air is exhausted outside.
Air Direction – Up and Down
Fingertip pressure on the horizontal louvers adjusts
the air direction up or down.
Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.
Cooling Descriptions
pads to
/ DECREASE
For Normal Cooling– Select the COOL mode and HIGH
or MED fan with a middle set temperature.
For Maximum Cooling– Select the COOL mode and
HIGH fan with a lower set temperature.
For Quieter & Nighttime Cooling– Select the COOL
mode and LOW fan with a middle set temperature.
NOTE: If you switch from a COOL setting to OFF or to a
fan setting, wait at least 3 minutes before switching
back to a COOL setting.
OR
www.GEAppliances.com
To open the vent, push the lever to the right.
To close it, push it to the left.
5