Wiring Instructions - FineTek SIS2 Operation Manual

11. Wiring Instructions

Attention! Wiring must be carried out by an electrician.
Make sure you comply with national and international regulations related to
the installation of electrical equipment.
The input power supply must be within the specifications of the product.

Turn off the power before wiring.

Make connections according to the wiring diagram below.

Insert the connector plug into the top socket of the
sensor and tighten the nut.

For hexagon nuts, please use a 14mm open spanner to tighten
torque of 1~1.5 Nm(0.1~0.15 kgf.m).
Wiring diagram:

R1 and R2 represent the load of OUT1 and OUT2 respectively.

To protect the sensor from damage in the event of system failure, adding FUSE
0.2A to the power circuit is recommended.

only represents the property. The actual wire color depends on the connector
purchased.
16
Torque: 1.5Nm