Configuring The Ibm-Pc And Compatible Software; Network Card Status Leds - GCC Technologies Elite XL-1208 Network Manual

Using the Elite XL with Ethernet
Note:
two arrowheads connected by a dotted line) as opposed to EtherTalk Phase 1 (one arrow
pointing in each direction).
4.

Configuring the IBM-PC and compatible software

Please refer to your computer's EtherTalk network card and Windows
documentation for configuration instructions.

Network card status LEDs

There are three yellow light-emitting-diodes (LEDs) inset into the face plate of
the Elite XL rear bezel. The right LED is lit continuously when a valid Thin
Coax (10BASE-2) connection is established. The left LED is lit continuously
when a valid UTP (10BASE-T) connection is established.
You must select the EtherTalk Phase 2 icon (two arrows pointing in each direction or
Close the network control panel.
SCSI
LOCALTALK
PARALLEL
RS - 422
10BASE -2
10BASE-T
UTP TX/RX COAX
5-9