Replacing The Lamp - Canon SX20 User Manual

A high-performance, compact, lightweight (3.9 kg/8.6 lbs) projector which supports of sxga+ resolution (1400 by 1050 dots)

Hide thumbs Also See for SX20:

Table of Contents

Replacing the Lamp

When the time of use of the lamp is 1400 hours or longer, the following message (two

types) is displayed for 10 seconds each time the projector is turned on.

• When the time of use is 1,400 to 1,500 hours

• When the time of use is 1,500 hours or longer

• This message will not appear again, if you select [No] in response to the

message "Do you want to display this message again?".

• Check the time of use of the lamp in [Lamp counter] from the System settings

menu. (P74)

• When replacing the lamp, turn off the projector, wait until the cooling fan

stops, remove the power plug from the AC outlet, and let the projector stand

for at least 1 hour. You may get burned because the main unit is very hot

Caution

immediately after the projector is turned off.

• When replacing the lamp do not touch the inner glass surface. The

projector's performance may degrade.

About the Replacement Lamp

This projector uses the following lamp.

Lamp type No. : RS-LP01

Be sure to use the lamp of the specified type.

A lamp can be ordered from your dealer.

Table of Contents

Table of Contents