Display Settings Menu - Canon SX20 User Manual

Display Settings
Menu
Make various settings related to input signals of
the computer and AV equipment as well as the
settings related to display.
Performing the auto pc
adjustment
Adjusting the total
number of dots
Adjusting the tracking
Adjusting the
horizontal position
Adjusting the vertical
position
Adjusting the number
of horizontal pixels
Adjusting the number
of vertical pixels
Selecting an input
signal type
Selecting a Screen mode
Selecting a menu
position
Capturing a logo to be
displayed
Selecting a logo
display position
Displaying a logo
(No signal input)
Displaying a logo
(No Show)
Displaying a logo
(Projector on)
When Ceiling-mounted
or for Rear Projection
52
[Auto pc adj.] ............... P52
[Total dots]................... P53
[Tracking] .................... P53
[Horizontal position] ....... P54
[Vertical position] ........... P54
[Horizontal pixels] .......... P55
[Vertical pixels] ............ P55
[Input signal select] ....P56, 57
[Screen settings] ........ P57, 58
[Menu position]............ P58
[Logo capture] ............. P59
[Logo position]............. P59
[No signal screen] ....... P60
[No show screen] ........ P60
[Projector on]............... P61
[Image flip H/V] ........... P61
Performing the Auto
PC Adjustment
The projector automatically detects the
input signal (ANALOG RGB) from the
connected computer to make the optimum
settings for the total number of dots,
tracking, and so on.
Display settings
Auto PC Adj.
Perform the auto PC adjust-
OK
ment function.
• Most computers can project an
image optimally using an auto PC
function.
• Signal types supported by the
computers that can use the auto
PC function are listed in the table
on page 84.
• If an image cannot be projected
correctly even with the auto PC
function, manually specify the
parameters ([Total dots] to [Verti-
cal pixels]) for the next item [Input
signal settings]. (P53 to P55)