Gravely Convertible 10 Shop Manual page 42

b. After installing magneto components, run all leads out through hole provided (in 11 o'clock position)
on bearing plate.
Figure 47 Installing Flywheel
18. Governor Arm and Linkage
a. Insert carburetor linkage in throttle arm.
b. Connect governor arm to carburetor linkage and slide governor arm onto governor shaft.
c. Before tightening clamp bolt, turn shaft counterclockwise as far as possible with a pair of pliers, pull
arm as far as possible to left (away from carburetor), tighten nut and check for freedom of movement.
Figure 46 - Typical Crankcase Breather
15. Flywheel
a. Place wave washer on crankshaft and place
b. Install starter pulley, lock washer and holding nut.
c. The rotating screen is fastened to starter pulley
16. Breaker Points
a. Install push rod.
b. Fasten breaker in place with two screws.
c. Place cover gasket in position and attach magneto
d. Set breaker gap at .020 full open. For ignitior
e. Make preliminary adjustments before installing
17. Carburetor
a. Insert a new gasket and assemble carburetor to
b. Refer to Service Section on carburetor adjustment
42
flywheel in position. The square key holds
flywheel on shaft.
Insert a bar between flywheel fins and tighten
holding nut to torque value specified in Clearance
Section.
with screws and spacers.
lead.
setting, refer to Ignition System Service.
breaker point cover. Be sure breaker lead grommet
is in place.
intake port with two screws.
procedure.